High Performance Carbon Fiber HTPLA-CF

High Performance Carbon Fiber HTPLA-CF combines engineering-grade performance with the ease and environmental-friendliness of PLA printing.  HTPLA 3D Printable Carbon Fiber, is a “super-material”.  Why is this material “the best”?
Compared to ABS, PET, and similar Polyester materials, HTPLA-CF has:
  • Easier and more reliable printing
    • No heated bed required
    • Lower processing temperatures, like standard PLA
    • Less warping and distortion when processing
  • More temperature resistance* for maintaining properties to higher temperatures
    • Most ABS, PET, and Polyesters get soft at 80C +/- 10C
    • HTPLA-CF maintains properties up to 120C or more (*when heat treated)
  • Higher strength and better strength-to-weight ratio for stronger parts with less material 
  • Improved surface hardness for less wear in abrasive environments
  • Less shrinkage and distortion for more accurate parts
  • Higher stiffness so parts hold their shape
  • Renewable biopolymer with low odor
  • Highly desirable black finish 
  • Improved toughness for less breaking when handling and easier processing
  • Higher HDT when heat treated for maintaining properties to higher temperatures.
  • Improved surface hardness for less wear in abrasive environments
  • Less shrinkage and distortion for more accurate parts

HTPLA-CF is based on  High Performance HTPLA v2.0, so it prints easily and can be heat treated for higher temperature performance with a potential Heat Deflection Temperature (HDT) in excess of 140C (285F) depending on processing. We had good results when heat treating in an oven at 110C (225F) for an hour. We recommend leaving the supports on your parts, placing them on a non-radiating surface (like glass, ceramic, or composite), and letting them cool in the oven to minimize distortion. Parts must be baked above 60C for any crystallization to occur.

  • Available in 1.75 & 2.85 (3) mm diameter
  • 500g 8″ diameter spool only

B9 Robot Builders Club – Official Claw Vendor for the Club! :-)

I am the official “Robot Claw” Vendor to the B9 Robot Builders Club.

 Finished Claw

 Claw Kit – Everything you need for your B9 Robot Build!


Here are some links to the B9 Robot Builder Website and a direct link to my Vendor Page at the club.

B9 Robot Builders Club HomePage

My Vendor Page at the B9 Robot Builders Club

If you would like a B9 Robot Claw Kit please email me at Davros.Dalek@Gmail.com


3D SLA Printer Added and New Ender3 3D FDM Printer Added – Print Farm is online.

Lab16 – 3D printer Wing Added.

I added an Older SLA printer to try my hand at SLA printing.  We also added a new Ender3 3D printer to my print farm.  If you buy an Ender3 3D printer, do yourself a favor – take the power supply that comes with this printer out of the box and immediately and throw it into the nearest garbage can.  Buy yourself a new reliable power supply.  I use the  MeanWell 24 Volt Power Supply (Amazon.com) and save your house from burning to the ground.  The Ender3 is a great little printer.  The power supply that comes with it, however, is a fire hazard and should be thrown away immediately.  Yes…the Meanwell Power Supply is expensive and is almost half the cost of the actual printer. – Buy it…The one that comes with the Ender3 will burn your home to the ground!